20120217 Duct Leak Affid 08142012v 'n�9S e Lot
Dact Leakage Affidavit
Permit #:
House address or lot number: l ib 1 ST AVE 2Cpyr
City: Zip:
Cond. FloorArea K): �� w t) Source (circle one): Estimated Measured
❑ Duct tightness testirig is not required for this residence per ekceptions listed at the end of this document
Air Handler in conditioned space? ❑ yes Er no Air Handler present during test? Qryes ❑ no
Circle Test Method: Leakage to Outside otal ka
Maximum duct leakage.
Post Construction, total duct leakage: (floor area x.08) = CFM @25 Pa
Post Construction, leakage to outdoors: (floor area x .06) = CFM o@25 Pa
Rough -In, total duct leakage with air handler installed: (floor area 'x .06) CFM @25 Pa
Rough -In, total duct leakage with air handler not installed: (floor area x.04) = CFM @25 Pa
_71 Test Result: 1 I� _CFM @25Pa
Ring (circle one if applicable): Open A <:6 �
Duct Tester Location: %A VM �1C1�- Pressure Tap Location:A�ljet%
I certify that these duct leakage rates are accurate and determined using standard duct testing protocol.
Company Name: �- Mt kO NC Technician: +1
Technician Signature:
Date: U )'Phone Number:
Washington State Energy Code reference:
503.10.3 Sealing. All ducts, air handlers, filter boxes, and building cavities used as ducts shall be sealed. Joints and seams shall comply
with Section M1601.3 of the Inte'mational Residential Code or 603.9 of the International Mechanical Code. Duct tightness testing shall be
conducted to verify that the ducta are sealed. A signed affidavit documenting the test results shall be provided to the jurisdiction having
authority by the testing agent. When required by the building official, the test shall be conducted in the presence of department staff.
Exceptions: 1. Duct tightness testis not required if the air handler and all ducts are located within conditioned space.
2. Duct testing is not required if the furnace is a nondirect vent type combustion appliance installed In an unconditioned space.
A maximum of slxfeetof connected ductwork in the unconditioned space is allowed. All additional supply and refurrl ducts
shalt be within the conditioned space. Ducts outside the conditioned space shall be sealed with a mestictype duct sealant and
insulated on the exteriorwith R -8 insulation for above grade ducts and R -5 water resistant insulation when within a slab Or
earth. .